Guage Reduction

TCT's rolling mills are capable of gauge correction & tempering. Precise thickness, tolerances can be held in annealed as well as eighth through full-hard tempers. Computerized automatic gauge control systems ensure end-to-end thickness consistency.

6" L4H MILL

Gauge : .025 / .187
Width : 4.000 Max
Max width @ max gauge 2.500
ID-Uncoiler : 16" / 20" / 24"
ID-Recoiler : 16" / 20"
Decambering, Tempering (1/8 %1/4) & Edging

OD-Uncoiler : 60" Max
OD-Recoiler : 54" Max
Line Speed : 200' Per Min Max
Uncoiler Mx : 2,500# Max
Recoiler Mx : 2,500# Max>

4HI UNITED MILL

Gauge : .010 / .225
Width : 2.000 / 10.000
(.187" @ 5.25" Max)
(.225" @ 4.00” MAX)
ID-Uncoiler : 16" / 20" / 24"
ID-Recoiler : 16" / 20"
OD-Uncoiler : 64" Max
OD-Recoiler : 64" Max
Line Speed : 75’ / 100’ PER MIN AVG

Uncoiler Mx : 5,000# Max
Recoiler Mx : 5,000# Max
*Temper thru full hard w/5" max
*Temper thru ž hard 6.500"
*Temper thru 1/2 hard 8.500” MAX*** - at 1/2 hard width higher than 8.5" are going to depend on the PIW (the bigger the more passes will be needed)
*10-15% Reduction per pass.
QH = 1-2 passes HH = 2-4 passes
3QH = 3-6 passes FH = 5 or more passes
*T-316 REQUIRES MORE PASSES>

** Poor shape at minimum gauge.
*** 1 TO 2 EXTRA PASSES AT MAX WITH

Z MILL

Gauge : .010 / .190
(we can roll down to .008")
Width : 11.000 / 24.000
Gauge Toler : +/-.0005
ID-Uncoiler : 20" ONLY
ID-Recoiler : 20"
OD-Uncoiler : 65" Max
OD-Recoiler : 61" Max
Line Speed : 180’/200’ AVG PER MIN - 600' Per Min Max

Uncoiler Mx : 17,000# Max
Recoiler Mx : 10,000# Max
Automatic Gauge Control
No Aluminum
No Coated Material
Gamma Ray - Entry / Exit

BLISS 4HI ROLLING MILL

Gauge : .010 / .187
Width : 3.000 / 11.000
ID-Uncoiler : 16" / 20"
ID-Recoiler : 16"
Line Speed : 275' Per Min Max

OD-Uncoiler : 60" Max
OD-Recoiler : 60" Max
Uncoiler Mx : 5,000# Max
Recoiler Mx : 5,000# Max

This website designed and maintained by IGD Solutions Corporation